Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
Posted on October 26, 2017 at 10:37The output Voltage expected is 6V and output is constant for 110VAC input. But the output is turning ON/OFF for 220V input. Please let me know to resolve this issue. I have followed the ST Design suite for the desi...
Posted on October 29, 2017 at 17:54Hello,in en.stsw-stm8069 firmware for the STM8S001J3 ist not included.Where can i download it?Thanks.
Posted on October 23, 2017 at 21:36I'm looking at file stm8l10x_gpio.c from the 'standard peripheral library'http://www.st.com/content/st_com/en/products/embedded-software/mcus-embedded-software/stm8-embedded-software/stsw-stm8012.html and there doe...
Posted on June 14, 2017 at 11:58Currently I have an issue when trying to allocate a structure to RAM.The issue I have is that my structure occupies a total of 373 bytes but the compiler/linker is insistent on trying to locate this structure in the z...
Posted on September 11, 2017 at 09:15Hello. Answer please. Is there a STM8 model that has a parallel external RAM interface? Thank you in advance.
Posted on October 27, 2017 at 12:33when i programming in stvp, it shows like this
Posted on July 29, 2016 at 18:11I have been using the GPIO_WriteBit() function to set/reset pins, but found it not working. The same function by register worked fine.Example:GPIO_WriteBit(GPIOB, GPIO_Pin_4, RESET); // this does not work!?GPIOB->ODR ...
Posted on October 25, 2017 at 07:04How to write option bytes in assembly language for stm8 mcu in stvd developer using cosmic compiler.I have to set Read out protection without using the stvp programmer.
Posted on October 13, 2017 at 16:23how to write option byte in compile time.Like when i compiling my code,at that time of compiling, i have to write values in option byte or set read out protection.
Posted on October 24, 2017 at 21:08https://community.st.com/community/stm8-community/stm8-mcus
