Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
I have followed the steps to create my lin.lib file from my LDF, but I need to add it to a STVD project, not one built with an extrenal makefile. I have tried adding the library to the default compiler path, and tried specifically adding it to the pr...
The PM0044 for the STM8 MCUs explain that data address space is 16MBytes linear. Ok, so why on the page 19 data address to a RAM memory has 16-bit wide (A15...0)?
I have Asus zen max pro set which has wonderful battery backup which gives the best battery standby time but it gets overheated fast to using it for a long time. I have contacted https://www.uaetechnician.com/asus-laptop-battery-replacement.html but ...
Hi everyone,I have the usual file.s19. I can set the 'Option Byte' up using the opportune tab in 'Cosmic'. Now I need to share my file.s19, but I need to share it with option byte already set up.Is there any way to do that?thanks Antonio
Posted on March 06, 2017 at 16:40Hello,Full RC5 decoding code with total STVD project file. Hope you will find it beneficial for your project.
I want to know if i can use the STLED524 with 64 LEDs or is the device just working when all 120 LEDs are connected.
My stm8l151k4t6 malfunctioned after I detached it from PCB in some heating way and then welded it back to the board. I wonder if the temperature I used to removed and welded the IC is too high. Anyone ever met this situation?
I have been using a STM8S105 successfully for a few months and recently, I have been experiencing problems with i/o on UART2. When I eventually probed the NRST pin I noticed that there is a sawtooth waveform on that pin, with no other circuit connect...
