Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
I have designed an isolated AC-DC converter, 300 to 590V AC input (400V AC nom) to 24V, 4A output using the L6566-BH Controller in eDesignSuite. Attaching the details herewith.Any further guidance regarding the Design implementation in actual Hardwar...
Hi, I am a newbie in writing code on MCU's.I am using STM8S003K3 with which several fan controllers are attached on different GPIO. I need to count PWM pulse whenever it comes on any port and then identify the pin no of that port. How to count pulse ...
HOW to code this table?void LCD_GLASS_Init(void) { /* The LCD is configured as follow: - clock source = LSE (32.768 KHz) - Voltage source = Internal - Prescaler = 2 - Divider = 18 (16 + 2) - Mode = 1/8 Duty, 1/4 Bias ...
We are planning to use the SCLT3-8BQ7, but do not want to connect any LEDs to LDi outputs of the chip. The datasheet does not mention how to connect these pins in this case.Can you please tell us if we should leave these pins floating?NOTE: This ques...
Hi,I am testing an application, and currently is working properly with HSI configured to 16MHz.Now I want to enable the HSE.I am using a NUCLEO-8S208RB. I have soldered an external crystal on X2, and i have configured the board with 12pF capacitors a...
Hi ST,We are implementing an M24C02-DRMF3 EEPROM based design and wanted to confirm the correct package marking for this device including part number, die version, date code and fab facility. Although the Data Sheet includes the WFDFPN8 mechanical in...
Hi, I'm looking for what I think is a Mosfet with this print, see the attached picture.I need to replace it because it's burned, but I don't know the features.Anyone can help me about ?Thanks a lotIvano
I wish to use STVD to set up a new workspace on a mapped common drive but it whereas I can see and go to a mapped drive with the Atmel IDE etc the STVD IDE doesnt appear to recognise it. Is this a known limitation or something I am doing wrong?
