Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
Hi,The UM0470 says:DM control register 2 (DM_CR2)FV_RAM Remap vector table in RAMThis bit is set or cleared by software. It remaps the interrupt vector table to a RAMlocation instead of program memory (usually 8000h).0: Vector table is in Program Mem...
can i get generated code from stm cube8 ?
Hi,For me to set the SWIM pin to (Input Float NO), I need to set all ports attached to pin 1, as follows: * NAME |DDR |CR1 |CR2 |ODR | Operation |FUNC * PA.0 - 0 - 0 - 0 - 0 - Input Float NI - SWIM * PA.2...
Hi,I am initializing studies with the STM8L050J3 using IAR.I made a development board and connected the in-circuit circuit as shown in the attached figure.Are there any other in-circuit pins that need to connect STM8L050J3 to ST-Link / v2?.
#include <iostm8l.h>#include <stdio.h>#include <string.h>#include <stdlib.h>#include "defs.h"unsigned int count = 0;@svlreg @interrupt void TIM1(void){ count += 1; TIM1_SR1 &= ~(0x01);}main(){ CLK_DIVR = 0x00; // Set the frequency to 16Mhz CLK_PCKENR...
In a project I'm working on, I am using the internal EEPROM of the STM8L151.I do not initialize the variables (of course), but the compiler automatically set them all to 0. This is a bit of a problem because my code looks for 0xFF to see whether or n...
I downloaded cosmic c compiler for stm8 and registered for license but I haven't received any license and it's been 2 days
void main(void) { float temperature = 0; const float Rp=10000.0; //10K const float T2 = (273.15+25.0); //T2 298.15 const float Bx = 3380.0; //B const float Ka = 273.15; float Rt = 0; //double ...
void main(void) { float temperature = 0; const float Rp=10000.0; //10K const float T2 = (273.15+25.0); //T2 298.15 const float Bx = 3380.0; //B const float Ka = 273.15; float Rt = 0; //double ...
