Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
The STM8 Standard Peripheral Library does not include example config files (header files) for STM8 Nucleo boards. Are headers for the Nucleo-S208RB available online? I though I ask before creating one... Thanks!
Hello everyoneI am to use the Timer3 of STM8s105C6T in order to measure the duty cycle of a specific signal.But I also want the MCU to reset if this signal is disconnected.I am using PWMI feature of this timer meaning that rising edge and falling edg...
Hey!Could you please tell me how to have access to older versions of STM8s std peripheral libraries?Apparently, it's no longer available on st.com Thanks a lot!
Hi, ST Community.I have a question about NC pin of M24C16.Is there any problem to connect NC pin to ground?Best regards.
I'm using the theseo-liv3f module to make a GNSS board. In this project, I am only acquiring invalid positioning data, and I would like to know if there are any hardware errors to be corrected. I've already paid attention to the reset pin which is ac...
Can the device STM8AF6226TCY be replaced by the STM8AF6226TCSSSY? Are they the same product? My customer wanted STM8AF6226TCY, but what we found was STM8AF6226TCSSSY.
We are using this low side driver in a battery controller and require reliability information in order to determine compliance with EN 1175
It was part of an RS232 board on a 20 year old CNC machine
