About Techn

Techn · 2024-06-20

I wanted to use the ioc and all the code from a project into another project. So, I copied the project and pasted in a workspace, then renamed the project, but ioc is not changed. So while opening, I get error messageInvalid Input: Must be project's ...

Techn · 2024-05-29

Hello,Target is power from another source. STlink from USB of laptopI was wondering if the power ON/OFF of STLINK and the target sequencing will damage either the devices? I had one STLINK v2 seems to be damaged while debugging and later it is not ab...

Techn · 2024-05-26

Hello,I am trying to make STM32F020c8t6 enter boot loader by connecting the Boot0 pin to HIGH via a 10k as given in some forms and pressing the reset. I connected the MCU UART1 to Laptop running Cube Programmer and use the UART option. The MCU uart1 ...

Techn · 2024-05-24

I observe a strange behavior for cubeIDE. I was working in a specific work space recently for few days. I was not in logged in state to "myST". I wanted to refer to other work space and switched the work space. It says "no project exists". Then I tri...

Techn · 2024-07-23

32F030 has less RAM, better to go with 32F103. Anyway better to do a prototype with a standard board. Normally modbus uses rs485 interface. Do you need to add rs232 to rs485 converter.

Techn · 2024-07-22

Is your project c or c++? when mixing c and c++ there will be some issues.

Techn · 2024-07-22

you can create a .h file with uint16_t array of pixels corresponding R5G6B5 or the needed format for your display(refer to datasheet). There are software such as lcd-image-converter. void ST7735_DrawImage(uint16_t x, uint16_t y, uint16_t w, uint16_t ...

Techn · 2024-07-19

You will need a transreceiver. https://controllerstech.com/stm32-uart-9-lin-protocol-part-2/#:~:text=The%20Lin%20protocol%20supports%20the,CS%20pin%20for%20the%20transceiver.

Techn · 2024-07-17

https://controllerstech.com/st7735-1-8-tft-display-with-stm32/#info_box

User statistics

User Activity

Rename the project does not rename the .ic file

Power ON/OFF sequence OF STLINK v2 and the target device

How to activate System boot loader for STM32F030C8T6 via UART1

Projects Not visible from some Work Space when logged out state

Re: Must I use a MCU supporting Modbus?

Re: CubeMX + TouchGFX code generation problem

Re: how to interface stm32F302r8 and SD card and tft display and i want to display image on the display using Ard ide

Re: I need product recomendation

Re: how to interface stm32F302r8 and SD card and tft display and i want to display image on the display using Ard ide