FAQs
KYou.1
Associate II
since ‎2020-02-20
‎2023-09-11

User statistics

  • 15 Posts
  • 0 Solutions
  • 0 Kudos given
  • 0 Kudos received

User Activity

TIM4 counter stops when ADC1 DMA less than 3 channels used.

2023-09-11
I know this is very weird behavior but it is quite easily reproduceable error. I am running Windows 11 on a laptop.CubeMX version : 6.9.1CubeIDE version : 1.13.1Board I am using is this. Looks like genuine STM32F103C8T6 chip.I could upload USB_DEVICE...

CubeIDE updated to 1.12.1 and bunch of errors generated

2023-05-03
I recently updated CubeIDE from 1.12.0 to 1.12.1 and it requires regenerating code from CubeMX 6.8.1After generating the code I see bunch of errors like below.I tried clean and build the project but no success. Is this known bug for 1.12.1? c:\st\stm...

STM32F429ZITx resets whenever PE1 pin pulled to GND by a npn type sensor.

2023-04-26
This is very weird problem as I have never experienced this kind of problem before.The board is hooked up to several NPN type limit sensor and connected PE0, PE1 etc.Every pins are defined as EXTI with Rising/Falling edge trigger and has been working...

HAL SPI cannot handle LSB data?

2020-11-13
I setup SPI using CubeMX and set First Bit as LSB First as described in the datasheet.I thought setting this will handle LSB data by itself however it is not working as expected.Below code only work with _SPI_HARDWARE_LSB defined which means I have t...

SPI write and reading from PN532 using HAL not working

2020-11-10
I am working on a project to communicate with PN532 nfc reader.The reader work just fine with arduino code using SPI.Below is the library I used to read and write data from PN532https://github.com/adafruit/Adafruit-PN532Now I switched to stm32 board ...
View more
Top