NUCLEO 64 board cannot connect to TileBox Pro

vlsireddy · ‎2024-07-10

Hi Team@ST,

1. I have a Nucleo 64 board.

2. I connected Nucleo64 board to TileBox Pro via SWD and [TX+RX].

3. Tried using STLINK in the STM32 Cube programmer option to program TileBox Pro and i get above error message.

Can you please let me know what is the issue here.

Thanks

Andrew Neil · ‎2024-07-10

@vlsireddy wrote:
TileBox Pro

Do you mean this: https://www.st.com/en/evaluation-tools/steval-mkboxpro.html - the SensorTile.box Pro ?

@vlsireddy wrote:
2. I connected Nucleo64 board to TileBox Pro via SWD and [TX+RX].

Give full details of exactly how you did that.

https://community.st.com/t5/community-guidelines/how-to-write-your-question-to-maximize-your-chances-to-find-a/ta-p/575228

Did you take care to disconnect the onboard Target of the Nucleo board?

A complex system that works is invariably found to have evolved from a simple system that worked.
A complex system designed from scratch never works and cannot be patched up to make it work.