I have set flash read protection --Level 1 - on chip STM32G431CBU6
Then I turn off this protection (set level 0).
But after that I see zeros (not FF) in all flash and I can't to full erase chip
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2022-11-20 02:10 AM
1 ACCEPTED SOLUTION
Accepted Solutions
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2022-11-20 12:30 PM
The ST-LINK Utilities have been deprecated for several years.
Tips, Buy me a coffee, or three.. PayPal Venmo
Up vote any posts that you find helpful, it shows what's working..
Up vote any posts that you find helpful, it shows what's working..
2 REPLIES 2
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2022-11-20 08:47 AM
Fixed the problem. The ST company is silent because the STlink utility does not normally work with the G4 series microcontrollers. It destroys the microcontroller. To solve the problem, I filled in the values ​​as in the picture and gave an entry.
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2022-11-20 12:30 PM
The ST-LINK Utilities have been deprecated for several years.
Tips, Buy me a coffee, or three.. PayPal Venmo
Up vote any posts that you find helpful, it shows what's working..
Up vote any posts that you find helpful, it shows what's working..