STM32CubeMX 6.11.0: automatically changing debug mode to JTAG (4 pins)

RajeevAroraCrcEvans · ‎2024-03-20

Hi,

In the project that I saved-as (to rename) the DEBUG was set to JTAG (5 pins).

After updating to STM32CubeMX version 6.11.0 I observe the JTAG (5 pin) option is unavailable.

Below change (i.e. switched DEBUG to JTAG (4 pins)) was made by software automatically while saving the file.

Regards,

Rajeev

Ghofrane GSOURI · ‎2024-03-21

Hello again @RajeevAroraCrcEvans

Thank you for your contributions and for your detailed explanations,

I confirm the issue on my side, it has been reported to STM32CubeMX development team .

Internal ticket number: 176646(This is an internal tracking number and is not accessible or usable by customers).

I will keep you posted with updates.

To give better visibility on the answered topics, please click on Accept as Solution on the reply which solved your issue or answered your question.

View solution in original post

Ghofrane GSOURI · ‎2024-03-21

Hello @RajeevAroraCrcEvans

First let me thank you for reporting.

I will check this issue internally then get back to you asap.

THX

Ghofrane

To give better visibility on the answered topics, please click on Accept as Solution on the reply which solved your issue or answered your question.

Ghofrane GSOURI · ‎2024-03-21

Hello again @RajeevAroraCrcEvans

Thank you for your contributions and for your detailed explanations,

I confirm the issue on my side, it has been reported to STM32CubeMX development team .

Internal ticket number: 176646(This is an internal tracking number and is not accessible or usable by customers).

I will keep you posted with updates.

To give better visibility on the answered topics, please click on Accept as Solution on the reply which solved your issue or answered your question.