I am using Winbond's Quad SPI NOR Flash memory (W25Q128JW). Which of Micron or Macronix should be selected for the memory_type of the OCTSPI setting parameter of cubeMX?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2022-02-10 5:27 PM
1 ACCEPTED SOLUTION
Accepted Solutions
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2022-02-10 5:59 PM
I'm not using CubeMX, but as I recall I used Micron mode when I was testing the Winbond parts​ on the H7 OCTOSPI parts.
Easy enough to change in the HAL structures.​
Tips, Buy me a coffee, or three.. PayPal Venmo
Up vote any posts that you find helpful, it shows what's working..
Up vote any posts that you find helpful, it shows what's working..
1 REPLY 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2022-02-10 5:59 PM
I'm not using CubeMX, but as I recall I used Micron mode when I was testing the Winbond parts​ on the H7 OCTOSPI parts.
Easy enough to change in the HAL structures.​
Tips, Buy me a coffee, or three.. PayPal Venmo
Up vote any posts that you find helpful, it shows what's working..
Up vote any posts that you find helpful, it shows what's working..
