How do we add a tool chain to STM32CubeMX/IDE? For instance SW4STM32?

ESala.1 · ‎2020-04-10

Nesrine.JLASSI · ‎2020-04-15

Hi @ESala.1

When you create an STM32 project from the CubeIDE you can only use STM32CubeIDE as Toolchain/IDE (you will notice that only CubeIDE exists and that it is greyed out).

Otherwise, if you create a new .ioc from STM32CubeMX you can choose the IDE that suits your needs.

Best regards,

Nesrine

View solution in original post

Nesrine.JLASSI · ‎2020-04-14

Hi @ESala.1

Please tell me which MCU you use.

Best regards,

Nesrine

ESala.1 · ‎2020-04-14

Hi Nesrine, Than you very much for reaching at me. I am using STM32IDE Ver 1.3 for the blue pill, STM32f103 Regards, Edwin <> Virus-free. www.avast.com <> <#DAB4FAD8-2DD7-40BB-A1B8-4E2AA1F9FDF2>

Nesrine.JLASSI · ‎2020-04-15

Hi @ESala.1

When you create an STM32 project from the CubeIDE you can only use STM32CubeIDE as Toolchain/IDE (you will notice that only CubeIDE exists and that it is greyed out).

Otherwise, if you create a new .ioc from STM32CubeMX you can choose the IDE that suits your needs.

Best regards,

Nesrine