How do I get the NUCLEO-H743ZI2 push button to work? And where's the example projects for the NUCLEO-H743ZI2?

[LPham.6]

When I used the STM32CubeMX for the NUCLEO-H743ZI, there's an option to enable NVIC EXTI line[15:10] interrupts for the push button. But when I used the STM32CubeMX for the NUCLEO-H743ZI2 there's no option to enable the EXTI line[15:10] interrupts for the push button.

Is this a bug with the STM32CubeMX?

[Tesla DeLorean]

STM32Cube_FW_H7_V1.7.0\Projects\NUCLEO-H743ZI\Examples\GPIO\GPIO_EXTI\readme.txt

Use the define USE_NUCLEO_H743ZI2 on the compiler command line to indicate you're using the ZI2 board. Couple of pin changes, and different LEDs as I recall

[LPham.6]

Thanks for the response.

I opened the readme.txt file from the STM32Cube_FW_H7_V1.7.0 directory and it's only meant for the NUCLEO-H743ZI.

With the NUCLEO-H743ZI, and using the STM32CubeMX allows configuring the EXTI and GPIO trigger. But this is not the case with the NUCLEO-H743ZI2. I have updated my toolset to be the latest too.

I'll try to use the NUCLEO-H743ZI project as a base and adapt it to the NUCLEO-H743ZI2. It doesn't make sense for the NVIC option to change in the STM32CubeMX for the same processor on different boards.

[Tesla DeLorean · Accepted solution]

The ZI2 should have the User Button connected to PC13 (default) or PA0 depending on Solder Bridges SB51/SB58

https://www.st.com/resource/en/user_manual/dm00499160-stm32h7-nucleo144-boards-mb1364-stmicroelectronics.pdf

The ZI also supports PC13 (default) or PA0 via SB173/SB180

Not seeing how these are materially different. The GPIO, EXTI and NVIC setting should be the same.

Sorry not using CubeMX so really can't talk to its deficiencies.

[LPham.6]

Hi Clive,

Thanks for all the help.

I decided to use my code that's configured in STM32CubeMX for the NUCLEO-H743ZI instead of NUCLEO-H743ZI2 and modified the pins that changed. It's too bad. I spent a lot of time trying to make the STM32CubeMX to work, but it's just not worth it.