STM32CubeMonitor (MCUs)

Resolved! STM32CubeMonitor 1.4.0 CPU critical performance issue

Hello everyone.I'm trying to work with STM32CubeMonitor to implement an industrial machine Life Test JIG using 12 ST-LINK v2 probes connected to STM32 microcontrollers by SWD protocol, but I'm facing very strange and anoying issues.This post will foc...

Resolved! STM32CubeMonitor Security/Credentials critical issues

Hi everyone.I'm trying to secure STM32CubeMonitor Editor and UI as defined to Node-RED, but is not possible secure STM32CubeMonitor.After define a user and password at settings.js (even only for STM32 CubeMonitor) the editor and UI breaks and are sim...

Resolved! I use serial port for communication. When I close the serial port, the chart of the dashboard will continue to draw the waveform for 10s instead of stopping the drawing immediately. What is the reason for the delay?

My node design is shown in Figure 1. The serial port input is connected to a function Fecg_raw(), as shown in the second picture.

Resolved! I want to change dashboard background. For example, I want change from white background to black background. But I don't know how to solve it.

Resolved! I want to use other computers, mobile phones and ipads for remote monitoring.

Another computer can ping the host successfully ， but can't connect to Dashboard. My phone and ipad are the same.What should I do？​​​

Resolved! STM32cubeMonitor (How to display the waveform of serial port data in real time)

I want to use STM32cubemonitor to receive serial port data, the serial port data is four channels. And draw the four-channel data.I can't find any relevant examples and don't know the implementation to split the data ...

Resolved! STM32CubeMonitor v1.4.0 not acquiring on Ubuntu 20.04

I was using STM32CubeMonitor v1.30 on Ubuntu 20.04 without any problems.After upgrading to v1.4.0 my previously working flows no longer capture any data.My ST-Link V3 probe shows green on the "acq in" and "aqc out" nodes..When I click on Start Acqui...

Resolved! STM32CubeMonitor-RF v2.8.1 is available

A new version of STM32CubeMonitor-RF has been released to fix some issues related to BLE OTA feature.The points covered by this release are :115533 and 117927 : During the OTA update, issue in the ACI_GAP_START_GENERAL_DISCOVERY_PROC command, change ...

Resolved! STM32CubeMonitor - validate SPI Rx buffer

I am receiving 32bit samples from an external ADC via SPI (DMA) on the STM32U5 (NUCLEO board) at a rate of 51200 samples/sec. Does the ST-Link v3e provide an interface that should allow me to reliably stream these to my PC for further anlayis/validat...