Hi Everyone!I just started my first STM32F4 project and I was wondering if there is an IDE that can show the content of a range of memory in form of a data plot.I tried to find someting on the web but had no luck so far.This means for debug I am ...
Hi, I have a STM32F407G-DISC1 board and I'd like to monitor some values (I/O pin states) using the CubeMonitor. However, when I try to configure the ACQ node no probe is found. I downloaded the latest version of the ST-Link driver and it does show up...
Dear all, I am desperately trying to access the JTAG's cells registers to monitor PWMs on a STM32F407G-DISC1. I have a few questions : To my understanding, SWD is connected to the DP (Debug Port) which itself is connected to various debug systems (JT...
Data is showing properly in Chart node but can't write data with write panel widget. When I try this work after change target board ( before : STM32F407G-DISC1 --> after : EVSPIN32F0601S1) the problem was resolved. I would like to know what is the di...
The code is a basic blinking LED and a free counter variable. The code runs well on the board. The list of variables is ok in STM32CubeMonitor.Thank you
I am trying to create a simple guitar tuner using FFT but currently I am stuck at getting the correct ADC value.When I tried passing 10Hz sine wave into my MCU, this is what I got from CubeMonitor which looks fine to me. This is the graph from the va...
Dear Community,I have started to use the STM Cube Monitor but I do not see through yet. I want to monitor some input and output pins of a STM32F4 and therefore I need the HEX adresses to type in in the variable node. I think I have to use the registe...
Hello,In STM32CubeMonitor in the variables node, we can add variable from the content of the RAM. Is it possible to do the same thing with the content of a register ? I want to monitor the sp register of an STM32F4.