I want to display ADC data on mychart -cube monitor. I found that varliable list remains inactive though it was made active under variables. I dont know what is wrong.
Hello, I am currently having a problem with a float / double variable, involved in a Timer interrupt, within a Nucleo H743ZI2 MB1364E.Considering the variable ‘double test_fluctuation_variable’, declared at the very top of the main.c, this variable i...
I am receiving 32bit samples from an external ADC via SPI (DMA) on the STM32U5 (NUCLEO board) at a rate of 51200 samples/sec. Does the ST-Link v3e provide an interface that should allow me to reliably stream these to my PC for further anlayis/validat...
I am trying to create a simple guitar tuner using FFT but currently I am stuck at getting the correct ADC value.When I tried passing 10Hz sine wave into my MCU, this is what I got from CubeMonitor which looks fine to me. This is the graph from the va...
