We are pleased to announce that the release 6.14.0 of STM32CubeMX is available. What is new in 6.14.0: Added the support for the STM32WBA6xxx microcontrollers and:Added the support for USBX multi-instanceAdded the support for the memory management to...
We are pleased to announce that the release 1.18.0 of STM32CubeIDE is available. What is new in 1.18.0: Microcontrollers, microprocessors, and board lists aligned with STM32CubeMX 6.14.0: Added the support for STM32WBA6xxx microcontrollers in the STM...
We are pleased to announce that STM32CubeProgrammer 2.19 is available What is new in 2.19: Support for the STM32WBA6xxx microcontrollers: Internal memory programmingOption byte/OTP programmingRDP regression with passwordSFI support Support for MCE N...
I have a complex project which i try to use CubeMX to generate the device trees for A-TF, OP-TEE and Linux, as well as code pieces for the M4.The crash is not visible in the STM32CubeMX.log file, but is printed in stderr:2022-04-14 14:55:51,876 [INFO...
I'm trying to download Starter Package to microSD card on STM32MP157F-DK2 via USB.I clicked "Open file", selected "FlashLayout_sdcard_stm32mp157f-dk2-trusted.csv", pressed RESET button, clicked "connect" and tried to download.However, STM32CubeProg...
Hello, I see two folders with the same name(STM32MP1xx_HAL_Driver) - one inside the CM4 and another one level above it.For the development of CM4 which folder to consider for the drivers?If it is the one inside the CM4 do I need to move the CMSIS as ...
Hello, I am trying to associate the DMA1 in M4 context with USART2 but whenever I click "add" on the right pane, I see no USART2 on that, on the contrary, I see UART4 it on DMA2 as shown below. If I try to put DMA2 in M4 context, UART4 now appears in...
Hi, We are using Stm32mp157a Processor in Our custom board. We are configuring PA5 as DAC1_OUT2.We want to configure DMA for DAC. But we didnot get an DMA setting tab in DAC configuration in stm32 Cube mx.How do i enable DMA for DAC? You can see in b...
Hi community,I'm facing problems to upload the flash layout on a custom board with the STM32CubeProgrammer. I tried with the last version (v2.10.0) but also older ones. The USB communication seems to be working fine as there are not checksum errors o...
Hi all,I am trying to debug an C++ user space application on A7using STM32CubeIDE.Build happens fine. But when i try to debug it i run into following errors.I can confirm the toolchain is installed both on system as well as embedded in CUBEIDE.How ca...
I was generate key-pair (privateKey.pem, publicKey.pem) by STM32MP_KeyGen_CLI and also got publicKeyhash.bin. After this i was sign FSBL TF-A bootloader and then make FIP (OP-TEE, U-Boot, configs) with "TRUSTED_BOARD_BOOT=1" option, kernel, rootfs. A...
Hello, I have a problem with programming EMMC through USB. Everything seems to be ok but when in U-Boot USB change from DFU to Gadget on Linux side everything stack (lsusb - stack). Of course, programming processes interrupt as well. I'm not sure whe...
