When generating u-boot an error occurs: stm32mp15-scmi-u-boot.dtsi:135.1-6 Label or path scmi not found. Following the steps in the OpenSTLinux 5.0 workshop document to update the device tree files. It mentions to include an scmi.dtsi file for u-boo...
Why are there different device trees for optee, TF-A, u-boot and linux kernel ? Since the hardware does not change between the boot stages, isn't it possible to consolidate it into one dts generated by CubeMX .The different boot modules consume the d...
I had the distribution package installed, deleted it and wanted to recreate it in another folder. However init repo gives the below message and repo sync only download the layers folder.repo init -u https://github.com/STMicroelectronics/oe-manifest.g...
Hello, I am currently researching about possibilities in STM32MP1 dual core. I am trying to create user program that uses HW Semaphore. I used program from wiki:https://wiki.st.com/stm32mpu/wiki/Hardware_spinlock_overview.and makefile described here:...
Isn't there a script file for generating RAW images for eMMC like the "create_sdcard_from_flashlayout.sh" file for generating RAW images for SD?Also, why is SD memory mapping different from eMMC memory mapping?
Hello, I am currently researching about possibilities in STM32MP1 dual core. I am trying to create user program that uses HW Semaphore. On M4 side is everything clear. But I cannot create program for A7 core. Here is what I think that I suppose to do...
Hello.I use a board STM32MP157A-DK1. I have SD-card with linux and now i try to run the board in KEIL. I have read file "Using STM32MP1 Cortex-M with Keil MDK". But I get error:Error: flash download failed.Also a can see:Full ship erase done.No Algor...
Hello , This question belongs more to IAR community but still asking it .I was checking this project of OpenAMP : STM32Cube\Repository\STM32Cube_FW_MP1_V1.6.0\Projects\STM32MP157C-DK2\Applications\OpenAMP\OpenAMP_TTY_echo\STM32CubeIDE\CM4\DebugIt has...
Hi When generating for CubeIDE firmware executes fine in both production and engineering mode. But for IAR/EWARM only engineering mode works. And, yes, I am aware of production mode not supported out of the box. Manual copy to target and start requ...
I'm trying to connect the MP157c-DK2 board in Engineering board. The st link is connected on the CN11 connector.On the st link utility it says detection failed and does not recognize the device.