cancel
Showing results for 
Search instead for 
Did you mean: 

Please go and visit our wiki pages to support your projects on our wireless product families.

Remi QUINTIN
ST Employee

Please go and visit our wiki pages where you can find a lot of information on our wireless product families (WB, WBA, WL) and the supported protocols: BLE, Zigbee, Thread, Matter, Lora, ...

To begin your technical journey, please start from this top page:

https://wiki.st.com/stm32mcu/wiki/Category:Connectivity

This top page will guide you to the first steps to develop a wireless application using connectivity protocols on ST wireless microcontrollers.

 

For BLE protocol, please visit:

https://wiki.st.com/stm32mcu/wiki/Connectivity:Introduction_to_BLE_with_STM32
https://wiki.st.com/stm32mcu/wiki/Connectivity:Introduction_to_Bluetooth_LE_Audio

You can find information on BLE Certification, BLE Features, BLE Mesh, BLE Audio, …

 

For Zigbee protocol, please visit:

https://wiki.st.com/stm32mcu/wiki/Connectivity:Introduction_to_Zigbee

You can find information on Zigbee certification, Zigbee Features, BLE-Zigbee concurrent mode, …

 

For Tread protocol, please visit:

https://wiki.st.com/stm32mcu/wiki/Connectivity:Introduction_to_Thread

You can find information on Thread certification, Open Thread Border router profile, …

 

For Matter protocol, please visit:

https://wiki.st.com/stm32mcu/wiki/Connectivity:Introduction_to_Matter

You can find an introduction to Matter, how to develop a Matter application,  certification, …

 

For LoRa WAN protocol, please visit:

https://wiki.st.com/stm32mcu/wiki/Category:LoRaWAN

You can find clears steps on how to start LoRaWAN on WL product.

1 REPLY 1
StevenG
Associate II

Where do we go for hardware implementation guidance for the STM32WB1MMCH6TR module?  Things like:

  • hardware keep-out areas for the antenna
  • Suggestions for what pins to avoid using (like PB0, PB1, PB2)
  • implementation suggestions/advice for VBAT
  • implementation suggestions/advice for BOOT0
  • software advice for how to deal with SMPS settings.  Even a statement such as "follow STM32WB15CC datasheet suggestions for 10 uH inductor and 4.7uF capacitor" would be helpful since without the module's schematics we don't know what was implemented internal to the module.