Complete
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2024-11-11 11:55 PM - edited ‎2024-12-08 7:30 PM
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2024-11-15 7:53 AM
Hello @Danu_Park,
Using Motor Control Pilot tool, "Graph & Record" left button, and select ELectrical ANGLEs to display:
Best regards.
GMA
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2024-11-14 12:16 AM
Hello @Danu_Park,
Could you verify motor connect connection: U, V and W phases and Encoder signal?
Did you try using Sensor Less as Main speed sensing and Encoder as Auxiliary to check that both reported electrical angles are aligned?
Best regards.
GMA
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2024-11-14 9:36 PM - edited ‎2024-12-08 7:29 PM
Complete
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2024-11-14 10:24 PM - edited ‎2024-12-08 7:29 PM
Complete
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2024-11-15 7:53 AM
Hello @Danu_Park,
Using Motor Control Pilot tool, "Graph & Record" left button, and select ELectrical ANGLEs to display:
Best regards.
GMA
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2024-11-17 5:28 PM - edited ‎2024-12-08 7:30 PM
Complete
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2024-11-18 12:28 AM
Hello @Danu_Park,
Using Motor Control Pilot "Advanced Configuration", you can tune the position control PID regulator:
Best regards.
GMA
