STM32H723ZG - no target detected

Mylossh · ‎2024-04-03

Hello everyone, I've designed a custom board with STM32H723ZG, previously based on STM32F767ZG. When I connect board with ST Link V2 prog through SWDIO, SWDCLK and GND, I get response that no target has been detected. I'm currently using ST-Link Utility software. If I desolder H723ZG and replace it with F767ZG, board works completely fine, without any issues.

What could possibly be issue, should I order ST-Link V3 prog for the H723 MCU?
Please check attached schematic of the board, MCU related stuff is on second page.
Thanks everyone in advance! 🙂

SofLit · ‎2024-04-03

Hello,

ST-Link Utility software is obsolete. Start using STM32CubeProgrammer tool.

To give better visibility on the answered topics, please click on "Accept as Solution" on the reply which solved your issue or answered your question.

View solution in original post

SofLit · ‎2024-04-03

Hello,

ST-Link Utility software is obsolete. Start using STM32CubeProgrammer tool.

To give better visibility on the answered topics, please click on "Accept as Solution" on the reply which solved your issue or answered your question.

MNapi · ‎2024-04-03

how did you solder this chip?

are you sure all power pins are connected (soldered properly) including PA13, PA14 for debugging ?

Mylossh · ‎2024-04-03

Looks like recommendation from @SofLit solved the issue! 🙂

Thanks a lot!!

Andrew Neil · ‎2024-04-03

That's good - please mark the solution.