Is STlink V3mini support Multi-path bridge USB to SPI/UART/I2C/CAN/GPIOs specific features?
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2020-09-24 3:59 AM
I have try to use STM32CubeProgrammer, but it seem do not support ISP mode to program STM target by Multi-path bridge USB to SPI/UART/I2C/CAN/GPIOs specific features.
But it work with ST-LINK-V3SET.
Labels:
- Labels:
-
CAN
-
GPIO-EXTI
-
SPI
-
ST-Link
-
STM32CubeProgrammer
-
UART-USART
This discussion is locked. Please start a new topic to ask your question.
1 REPLY 1
Options
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2020-10-16 7:23 AM
Hi @PGeor.2 ,
Multi-Path bridge is not supported in STlinkV3mini, it is supported in ST-LINK-V3SET .
best regards,
Houda
