IAR STM8S PROGRAM DEPLOYING
I am using IAR EMBEDDED WORKBENCH FOR STM8s. I am running a simple led blink program. But I am facing while deploying to device. It shows the message "FAILED TO LOAD DEBUGEE". Please answer about this issue.
Others: hardware and software
Discuss hardware and software design challenges, including NOR flash storage, OTA updates, component ID, and thermal management.
Forum Posts
Want to know the memory roll over scenario in case of byte write in EEPROM M95M02-A125..
The EEPROM range for M95M02-A125 is from 0x00 to 0x3ffff. When a byte write is initiated at 0x40000, it overwrites the contents of the location 0x00. Is this the expected behavior? In data sheet the roll over for page write is mentioned, like the in...
How to configure mytimers as counter in STM8s003f3
Hey guys, i have problem about counters, i have a constanst frequency square wave ring tone signal and this signal have to come to my mcu's input pin and i have to detect it that is ring tone, i think i will gonna do this with counters, i have to ope...
Resolved! STNRGPF01 related questions
Hello, I found a problem in eDesignSuite when i try to use STNRGPF01 (PFC boost interleaved IC).At input current sensing the ICS Target Voltage is 3.00V and in the datasheet the ICS Target Vltage looks like it is 1.25V (also in the Help section of eD...
Can we use BlueNRG-1 component with STM8s controller?
Does BlueNRG-1 component works alone as a single chip or does it need to be configured with other MCU for its functionality?
STVD Software is not responding
Hi, I am using ST Visual Develop environment for programming of STM8S207, i am using 4.3.6 version. Problem is, whenever i give save command, STVD is halt and shown "Not Responding" My laptop configuration is Pentium Dual Core, 2.0GB RAM, Window ...
How to add standard libraries for STM8S001J3 microcontroller in Cosmic Stm8s ?
I am using Cosmic STM8s ide for my STM8S001J3 micro controller. I am not able to add the standard libraries for the microcontroller in cosmic ide. please help me out with this issue.
Resolved! I2C EEPROM 24LC16b, 24LC65 problem ...
Hello,I have a problem with I2C eeprom 24LC16b and also with 24LC65. Altough the internal buffer is 16 bytes I can sent at once only 15 bytes (14 characters + 1 null char) and the same is aslo for 24LC65 (Instead of 64 I can store only 63 chars at on...
