Others: hardware and software

The max analog sense voltage given in datasheet does not calculate correct for VND5T016ASP-E high side driver?

I am working with VND5T016ASP-E high side driver. By looking at the datasheet in current sense section, it says Vsense is tested at Iout =20A with Rsense =3.9kohm. by calculation I am not getting anywhere closer to 5V which is given as min value but ...

Receive a string 9 chars long through UART1

I would like to receive a string through the UART1, its format is from 000000000 to 999999999, However when I send the string only the first object is read and it is repeated nine times and the other values are lost.I am using this function to read t...

I need to know the marking on M24512-DRDW3TP/K. I have checked the data sheet and it has no information. Upon checking the part is has 412RQ on the top.

Is the document DS9884 applicable to STM8AF6226TDSSS, which is not in sale?

Hi. I'm using a STM8AF6226TDSSS chip. I can't find the specific model number on the website.STVP set STM8AF6226TxSSS as a different device apart from STM8AF6226. So what's the difference? Is the datasheet applicable?

const array is overflowing .text segment when there is plenty of room

I am using a stm8s103f which has 8K flash. My project compiles fine using the cosmic compiler. I get a map that looks like this .start 00008080 end 00008080 length 0 segment .const start 000080a1 end 00008924 length 2179 segment .text start 00...

M95M02 is no working?

Working way: W and Hold is high, Other SPI BUS.First we send "RDSR" Command but MISO is low like no working, so I try send "WREN" and "WRSR"but is no working.

May I know the Electrical behaviour of M95160-A125 when device is not selected (chip select is driven high) and VCC is connected to 5V ?

Dring this time, will there by any electrical flow in other pins like SDI/SDO. If there is electrical flow, then I am interested to know how big it is ?​

hai stm8l052c6t6 microcontroller have its own boot loader on it or not? if it have how to program the stm8l052c6 using ST LINK V2 by SWIM connection? when i programming the micro controller an error is occur that is "cannot communicate with the device."

hai i am using STM8L052C6 micro controller. i have a problem ("cannot communicate with the device") while loading the program into ic using STvisual programmer through ST-LINK V2, have any solution for this? Thanks in advance

ic STM8L052C6, Programmer ST Visual developer, ST Visual programmer and writing through ST LINK V2

Hai, I am using STM8L052c6 micro controller and the programmer ST Link V2 , but stvp showing error "cannot communicate with the device ".How can i resolve the problem? Thanks in advance .