About Toneski

Toneski · 2023-10-25

Hi All,I have a 407 connected to an FPGA using the FSMC interface.When I compile my device configuration from ST Cube, the WaitSignalPolarity value in the MX_FSMC_Init routine is always set to: FSMC_WAIT_SIGNAL_POLARITY_LOW. On my system I need this ...

Toneski · 2024-11-18

Hi oleq96,We need more information.1. I always worry when people state "I checked the wiring and it is fine.". Can we see how you've connected your display? - Please upload a schematic (a JPG will do, but must include connection detail - capture it f...

Toneski · 2024-10-22

Hi ferro,Yes - you need to rebuild all the HAL source files every-time you change the .IOC file. The .IOC file is the file that allows you to allocate pins, clocks & enable the hardware blocks within your device (like enabling & configuring a new SPI...

Toneski · 2024-10-09

Hi Ferro,It looks like because you have upgraded/changed CubeIDE, that possibly the HAL drivers for your project need updating. Press the Cog wheel icon - or menu <Project/Generate Code>. This should update any source to the version of CubeIDE you a...

Toneski · 2023-12-01

Hi @FBL,Thats great news. Is there anyway that I can access the internal ticket, so that I may watch its progress?Also, do you know when this might be fixed? The next release maybe?Thanks for all your help.Regards,Toneski

Toneski · 2023-11-29

Further info - I reconfigure the FSMC_BTR1 reg soon after the FSMC is setup. Do you think I should re-configure the Wait signal polarity here too?// Correct configuration for FSMC BTR1 register.. (Appologies for the incorrect tabulation - your websit...

User statistics

User Activity

Setting the F407 FSMC WaitSignalPolarity default value

Re: SSD1963 with STM32F407 using FSMC

Re: CubeIDE 1.16 is requiring code generation with every press of Ctrl+B

Re: CubeIDE 1.16 is requiring code generation with every press of Ctrl+B

Re: Setting the F407 FSMC WaitSignalPolarity default value

Re: Setting the F407 FSMC WaitSignalPolarity default value