About rclar.6

rclar.6 · 2024-02-12

I am trying to use a CRC32 generated with srec. This is all going OK. Then I remembered the hex file not the elf file was being modified by my script.I am trying to get the de-bugger to load the data from a hex file and the symbols from an elf file...

rclar.6 · 2022-11-23

st-stm32cubeide_1.10.1_12716_20220707_0928_amd64.deb_bundle.shInstalled it using this under sudo. But the j-seeger part failed.

rclar.6 · 2020-03-30

I want to specify the HEX file for data into the STM32 and the elf file for symbols used in the debugger. The User interfec has changed though and I seem to only be able to get one or the other (i.e. just the hex or just the elf).This is a necessary ...

rclar.6 · 2020-02-26

How do I initialise it? Do I need to swith on an internal peripheral Bus?

rclar.6 · 2024-10-17

Is there a work around for this? Is it possible to detect if the CAN module is in a locked state and then free it?

rclar.6 · 2024-09-24

This worked for me! Thankyou. (I cannot find the 'accept as solution button)

rclar.6 · 2024-09-24

I can run full stm32ide on my MAC M2 (but I guess it may be simulated x86 64 bit). However it works and its snappier than my i7 NUC

rclar.6 · 2024-09-23

By creating a new project in a given file directory, and not storing in the workspacethe config and driver files can be committed to git. Below link to git hum to an STM32IDE Nucleo project that should simply compile when restored. https://github.com...

rclar.6 · 2024-09-17

Why are workspaces required. Most projects I use are defined by their git directiories. Is there any way to make stm32CubeIDE use JUST one directory per project? This would seem a far simpler way of working.

User statistics

User Activity

debugger instance incorrect but cannot delete

Trying to create a project, seems to be hanging at license agreement

I have been using a linux script generated CRC code instered into a HEX file on some other STM32 products. I am now implementing this for the STM32G431. The GUI is the 1.3.0 IDE. This has changed the debug config.

Trying to use CORDIC on a NUCLEO-G431RB. I have some example code but its almost like the CORDIC module is not responding. In CubeMX I have enabled CORDIC but no MX_CORDIC_Init() function appeared in the main.c code (should that function be there?

Re: HAL CAN transmit timeout bug?

Re: IDE hangs on start - new symptom of sickness ?

Re: Installing STM32CubeProgrammer on Raspberry Pi

Re: Trying to create a project, seems to be hanging at license agreement

Re: Trying to understand workspaces and projects