About LMyle.1

LMyle.1 · 2023-10-11

Hello, MCU:STM32H753XIH6TR Is it possible using an ST Link from a 20 pin JTAG connector to interface with an MCU to send and receive commands via UART to PUTTY/Real Term perhaps another protocol? I need it to do through the st link to avoid any hard...

LMyle.1 · 2022-10-18

LMyle.1 · 2021-11-23

Is there any training available around FD CAN communications ?

LMyle.1 · 2021-10-22

Hi I would like to know what heat sink is compatible with the STM32H753I EVAL 2FG evaluation board.It seems there are holes outlined around the MCU where the heat sink can be applied?Best regards,Luke

LMyle.1 · 2021-09-15

Please see .ioc test attatched.

LMyle.1 · 2021-11-24

@Peter BENSCH is ther any source on how to configure the timing paramaters?

LMyle.1 · 2021-09-15

My question is why am I unable to change PA1_C as timer 5 in my .ioc file thank you !

LMyle.1 · 2021-08-12

thanks

LMyle.1 · 2021-08-12

Windowsthanks.

LMyle.1 · 2021-08-12

In both CUBE MX and IDE version of cube mx : 6.2.0 software package:1.9.0 Cube IDE: 1.6.1My colleague is having the same issue. Thanks

User statistics

User Activity

Semi Hosting to Putty

Hello I am interested in an ST-Link cable connector which requires the least amount of pins from a JTAG connector can you please reccomend something please ?

Training on FD CAN

Heat Sink compatible with STM32H753I EVAL 2FG

Hi I am having issues with cube MX, why am I unable to set timer 5 to anything when I have PA1 and PA1_C in use ?

Re: Training on FD CAN

Re: Hi I am having issues with cube MX, why am I unable to set timer 5 to anything when I have PA1 and PA1_C in use ?

Re: Hi I am concerned about the following microcontroller : STM32H753XIH6TR When using cube Mx to configure the timers on pin PA1_C the options specified in the data sheet are not avaliable. How do I access these functions?

Re: Hi I am concerned about the following microcontroller : STM32H753XIH6TR When using cube Mx to configure the timers on pin PA1_C the options specified in the data sheet are not avaliable. How do I access these functions?

Re: Hi I am concerned about the following microcontroller : STM32H753XIH6TR When using cube Mx to configure the timers on pin PA1_C the options specified in the data sheet are not avaliable. How do I access these functions?