2024-09-03 08:01 AM
I am currently facing an issue with my STM32H743BITB microcontroller while using the STM32CubeProgrammer. I can successfully load the bootloader, and the software indicates that the boot has been loaded correctly. However, when I attempt to read the data, I encounter the following error message: "Error: Data read failed."
I would greatly appreciate your assistance in resolving this issue. Please let me know if there are any specific steps or settings I should verify.
2024-09-04 08:38 AM
Perhaps the issue is with your design / implementation? Share salient portions of schematic, or link to board on-line if from a third-party vendor.