I can't make stm32_programmer_cli work. Please help?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2023-02-27 7:20 AM
The program can't find any ST-Link connections:
But I can use the STM32CubeProgrammer to flash my board via ST-Link/V2 SWD.
Could you please help me to figure out what is missing?
I need to write a program to flash the board and I can't even see it! Please help.
Thank you.
Solved! Go to Solution.
- Labels:
-
STM32CubeProgrammer
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2023-02-27 7:54 AM
The ST-LINK is using the SWD interface, the "USB" connectivity is looking for STM32 directly connect via USB, either in Boot Loader mode, or with DFU Device Firmware.
STM32_Programmer_CLI -c port=swd
Up vote any posts that you find helpful, it shows what's working..
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2023-02-27 7:54 AM
The ST-LINK is using the SWD interface, the "USB" connectivity is looking for STM32 directly connect via USB, either in Boot Loader mode, or with DFU Device Firmware.
STM32_Programmer_CLI -c port=swd
Up vote any posts that you find helpful, it shows what's working..
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2023-02-27 8:47 AM
OMG... Of course!!!
I did not know that parameter. I need to improve my skills by looking for information in the manuals. Thank you very much.
