Update Problem

[UniRob]

After STM32CubeMX update from version 6.10.0 to 6.11.0 WorkBench give me and error (see picture Worckbench.jpg attached).

How to solve this problem ?

I don't find any configuration on Wokbench to specify new STM32CubeMX installation.

[Souhaib MAZHOUD]

Hello @UniRob !

Thank you for bringing this issue to our attention, I will check it internally and get back to you as soon as possible.

Regards,

Souhaib

[Souhaib MAZHOUD]

Hello @UniRob ,

A new version of CubeMX 6.11.1 has been released. Could you install it and check if the problem persists?

Thnx,

Souhaib

[UniRob · Accepted solution]

Thank you very much, I solve the problem.

STM32CubeMX was automatically update to 6.11.1 and STM32CubeIDE to 1.15.0 to.

The problem was that MotorControl Workbench was not automatically update .

Installing MotorControl Workbench 6.2.1 the problem is solved.