‎2024-04-24 12:04 AM
After STM32CubeMX update from version 6.10.0 to 6.11.0 WorkBench give me and error (see picture Worckbench.jpg attached).
How to solve this problem ?
I don't find any configuration on Wokbench to specify new STM32CubeMX installation.
Solved! Go to Solution.
‎2024-04-28 11:14 PM
Thank you very much, I solve the problem.
STM32CubeMX was automatically update to 6.11.1 and STM32CubeIDE to 1.15.0 to.
The problem was that MotorControl Workbench was not automatically update .
Installing MotorControl Workbench 6.2.1 the problem is solved.
View solution in original post
‎2024-04-24 9:00 AM
Hello @UniRob !
Thank you for bringing this issue to our attention, I will check it internally and get back to you as soon as possible.
Regards,
Souhaib
To give better visibility on the answered topics, please click on Accept as Solution on the reply which solved your issue or answered your question.
‎2024-04-25 6:07 AM
Hello @UniRob ,
A new version of CubeMX 6.11.1 has been released. Could you install it and check if the problem persists?
Thnx,
