STM32CubeMX STM32H750 I2S2 pin configuration.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2021-01-04 09:23 AM
I want to use the STM32H750. I want to configure the I2S2 to use the port PI0..PI1, but the CubeMX tool will not alloud me to do it. According the data-sheet it should be posible.
Br. Poul-Erik.
Solved! Go to Solution.
- Labels:
-
I2S
-
STM32CubeMX
-
STM32H7 Series
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2021-01-05 05:47 AM
You're right @Poul-Erik , issue will be fixed.
Thanks for your contribution, Khouloud
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2021-01-04 11:12 PM
Hello @Poul-Erik ,
It will be internally checked then I'll get back to you.
Khouloud
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
2021-01-05 05:47 AM
You're right @Poul-Erik , issue will be fixed.
Thanks for your contribution, Khouloud