Hi, I am using a NUCLEO F401RE nucleo and I am trying to make the LED blinking using cube IDE. when i try to build the project, it gives me an error like you can see on the picture below. Do you know how l can solve this problem please?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2020-05-17 11:48 PM
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2020-05-18 12:19 PM
finaly its ok. This article solve my problem (https://community.st.com/s/question/0D53W000002dj17/makefile44-error-1)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2020-05-18 12:54 AM
Looking at your console log sounds you have some special char within your path such is not helping ....​
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2020-05-18 10:28 AM
I'm not sure to understand. L'm really not familiar with the software
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2020-05-18 12:19 PM
finaly its ok. This article solve my problem (https://community.st.com/s/question/0D53W000002dj17/makefile44-error-1)
