STM32CubeProgrammer v2.17.0 release information New features:• Added the support for the STM32MP25xx microprocessors in the STM32MP2 series – Flash memory and OTP programming, SSP support Added the support for devices in the STM32WB0 series: STM32WB0...
Hello, I am using Hyper-V as my VM, since I am on windows, and trying to bring up the STM32MP257F-EV1 development board. I have verified the programmer is installed correctly and have verified that Hyper-V's enhanced mode is running but every time I ...
Hello, I am currently trying to bring up the STM32MP257F-EV1 development board and running into an issue. I am following the instructions provided in this link: Populate the target and boot the image - stm32mpu, but I am using UART instead of USB. Wh...
Hello, I am trying to set up an ST link on the Cubeprogrammer, but whenever I try it gives me an error which states: "Error: No STM32 target found! If your product embeds Debug Authentication, please perform a discovery using Debug Authentication". I...
Custom MP157AAA3 board. SD card formatted with ECO 5.0.0 using the SD tools using the files from the starter package. (including rootfs etc..) . Build the TF-A, OP-TEE (in SYSRAM), U-boot and kernel from the ECO 5.0.0 sources.Kernel generates the m...
The following compilation failure occurs when using cubeMX (6.12.0) to generate the STM32MP135DK+threadX project：tx_initialize_low_level.S:147: undefined reference to `_stack_bottom'collect2.exe: error: ld returned 1 exit statusmake: *** [makefile:66...
Hi all.I'm working through the lab material for the STM32MP1 workshop and have run into a snag after following the "extra hands on" presentation "Lab-MP15_FromPartNumber_To_BasicDeviceTree_with_CubeMx.pdf". My high level goal is to get binaries (TF-A...
When I try to use JTAG connect to MPU, the watchdog will reset whole system.Early, I have this post Solved: System reset during kernel debug - STMicroelectronics Community. With you suggested solution I'm able to disable Watchdog. Now I have time to ...
Hello, I am trying to boot a Hi-Speed USB Device application using the STM32MP135F-DK by loading it from an SD card to DDR3, but it is not working. To investigate the issue, I am trying to boot CDC_Standalone that is included in STM32Cube_FW_MP13_V1....
Hi all,On my Ubuntu 20.04 computer with newly installed STM32CubeProgrammer, I cannot launch the STM32CubeProgrammer v2.17.0 using either the launcher or the programmer using command line. Not sure if it is a graphics card/driver compatibility issue....
STM32CubeProgrammer v2.17.0 release information New features:• Added the support for the STM32MP25xx microprocessors in the STM32MP2 series – Flash memory and OTP programming, SSP support Added the support for devices in the STM32WB0 series: STM32WB0...