I'm attempting to run an OP-TEE Trusted Application on the STM32MP157F-DK2 running OpenST Linux version stm32mp1-openstlinux-6.1-yocto-mickledore-mp1-v23.06.21. I've followed the guides here and here, but both end up producing the following error whe...
First acquaintance with STM32mp157FDK2. A couple of weeks ago I bought two sets to try. In a week I figured out how to put together my image with Yocto. And today what was supposed to happen happened. I connected the KIT to the power supply with PD3....
Hi there, I'm trying to integrate in my linux distribution (custom board based on STM32MP153) a LTE Modem (uBlox Lena R8) which is controllable via USB. At the powerup is see that the device tries to enable the USB (it should bring up 8 virtual COM/t...
Hi,How can I install a USB serial adaptateur https://ftdichip.com/products/chipi-x10/When the usb adaptateur is connected there is not ttyS0 or ttyUSB0 !thank you.
Hi,How can I install pyserial.py python modul on Discovery kit STM32MP135F.I would like also install pip Thank you for your help.Olivier
*I've imported successfully of STM32mp157 dk-1 board 's schematics in altium designer and I don't know whether this processor is over advanced for application or it is must need to use for our product. even though I'm newbie with lesser yr of exp ,...
Hello,We are currently working with the STM32MP157F-DK2 board and the on-board SDRAM (DDR3L). The memory map says that region (0xC000000-0xDFFFFFFF) is for the DDR system, however when we try to write to some of the memory locations inside this range...
Hello everyone,we have developed a custom board based on stm32mp157 chip. We also forked the tf-a and u-boot from meta-st layer. If we flash an sd card using the flash layout, image works. But my goal is to copy the files from linux host machine, whi...
Processor stm32mp157f, our board design similar to dk2.In my STM32CubeMX generated device tree (dunfell) I have added the following:/* USER CODE BEGIN root */soc {vrefbuf@50025000 {status = "disabled";};};/* USER CODE END root */I have my vref pin co...
I just saw this. It's from STM32MP157 discovery board.Notice that DQ9 is attached to E3.This schematic is the RAM DDR memory: They are connected correctly. The index of DQU2 is the 10:th index of DQ, also DQ10. But the naming of the net labels seems ...
