Hi, I have STM32MP157C-DK2 board and I am running Linux Yocto on it.Now I want to run my own BMP files on the board but I am not getting how to do this. Can anyone help me the procedure to run this.RegardsSrikanth.
Hello,We would like to setup the STM32MP157C-DK2 board. But we couldn't find any information related to the recommended power supply. Could you please suggest us that which Power Supply 5V/3A adapter or connector should we use? It would be great if y...
Hello, I try to push the linux Kernel to STM32MP157C-DK2 board. I have made the reboot of my board. After the reboot I don't know why the screen of my board turns on then I can see the logo of ST and then my screen turns off. How can I correct that. ...
Hi all,I am using a STM32MP157C-EV1 and testing the digital microphones with ALSA. For testing purposes I am just using the arecord command. All works fine if I use the S32_LE sample format:$ arecord -D hw:0,4 -f S32_LE /tmp/rec.wav Rec...
HI, All.I would like use speaker output in STM32MP157C-EV1. I revised the wiki but there aren't references about how play audio with speaker output. Is it enable speaker output to this board? Is it possible enable this output to play audio?Regards!Al...
I'am a newbbie on STM32MP1 and linux embedded.I want to use available pins on STM32MP1-DK2 to as buttons input. I want to use CN14 connector pin (1 to 4) as buttons inputs.I've modified the stm32mp157c-dk2.dts adding these lines: buttonkeys { compat...
Hello,I am working on the evaluation board STM32MP157CDk2I am trying to add my code in the main method while loop in order to toogle pins.I added the following code:while (1) { /* USER CODE END WHILE */ HAL_GPIO_TogglePin(atoi(1), GPIO_PIN_1...
I tried to test a UART link on the USART3 port of the STM32MP157C-DK2 board.For that I followed the instructions of the Wiki for the modification of the Linux kernel:I changed the settings in "arch / arm / boot / dts / stm32mp157a-dk1.dts" to put the...
I have a STM32MP157C-DK2 eval kit and am looking into Bluetooth mesh. According to Murata the wireless \ bluetooth module that contains a Cypress part is mesh compliant and the board has v5.50 of BlueZ so theoretically the version of Linux supports i...
I am going to extend some GPIO for 157 for keyboard, I found on EV board is a MCU of STM32L157 to implement, do you have any firmware information about this MCUSource code or I2C protocol, or have other similar chips