xcube-Touchgfx 4.17.0 generator not appearing in category menu in STM32cubeide 1.6.1?

[Mkuma.5]

i did installed from software packages of cubeide. But generator is not appearing on the category menu to configure.

[Romain DIELEMAN]

Hi,

You need to enable "TouchGFX Generator" for your project by clicking on the "Additional Software" button and enabling TouchGFX 4.17. Follow this article in the documentation.

/Romain

[Mkuma.5]

i did not find anything like "Additional software" button on my category Menu

[Romain DIELEMAN]

Hi,

Click on the Software Pack button in the top of your screenshot. It will open a dropdown menu where you will be able to select Additional Software like in the screenshot in the article I shared.

/Romain

[Romain DIELEMAN]

Actually my bad, in this dropdown menu click on "Select Component" and not Additional Software which does not exist sorry.

/Romain

[Romain DIELEMAN]

See below screenshot 

/Romain

[Mkuma.5]

i went to select components and installed xcube-Touchgfx 4.17.0 . but its not appearing in my categories for configuring. My question was the same from the beginning. Is there a way in settings to see additional packages to categories menu. So that i can configure ex: RGB8888 etc.,?

[Romain DIELEMAN]

Could you share a screenshot of how you configured STMicroelectronics.X-CUBE-TOUCHGFX in the Software Packs Component Selector ?

/Romain

[Mkuma.5]

sure. we did not configure but only installed. But not appearing in my categories menu for configuring.