Error while connecting g070rb

AVerm.4 · ‎2021-05-20

When i try to connect g070rb nucleo board i get my LD1 blinking continuously and on my pc it shows usb device not detected.

TDK · ‎2021-05-20

Perhaps you are using a USB power-only cable. Try a different cable. Try a different USB port. Reboot your PC. Try a different board. Try a different computer.

If you feel a post has answered your question, please click "Accept as Solution".

AVerm.4 · ‎2021-05-20

@TDK Checked all the possible situations you mentioned. It's been couple of months since i used this board. I'm not able to figure out what exactly is happening. Is there any way i can connect to Stlink v2 externally.?

Mohamed Aymen HZAMI · ‎2021-06-03

Hello @Community member,

Try to reinstall the board driver on your computer.

Mohamed Aymen.