CAN protocol

[NANWA.1]

Hi STM team,
I want to use CAN standard and extended protocol both in a single project is it possible?
Regards, 
Em

[LCE · Accepted solution]

STM32G0x1 has a CAN-FD protocol, so it supports all possible CAN protocols (not 100% sure).

Switching between these is up to your firmware.

You might want to check this:

https://www.st.com/resource/en/application_note/an5348-introduction-to-fdcan-peripherals-for-stm32-product-classes-stmicroelectronics.pdf