MCSDK 6.3.2 connectAlgo.log file not found
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2025-04-18 7:10 AM
Hello,
I got a error message during control project genaration
"
It is not possible to create a motor control project with the FOC algorithm using the selected hardware
. No proper path for motor control signals was found for the following mandatory features:
 - Phase Voltage Generation
 - Current Sensing
For more details, please, look at the following log file in your home directory: .st_workbench/connectAlgo.log
"
, but it was unable to find connectAlgo.log in the folder \AppData\Local\STMicroelectronics\MC_SDK_6.3.2\Utilities\PC_Software\STMCWB\.
Solved! Go to Solution.
- Labels:
-
6-Steps
-
FOC
-
MC Workbench
-
MCSDK6
-
STM32 Motor Control
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2025-04-18 7:15 AM
Hello @Creative_Stone,
File is located in home directory: ~/.st_workbench
Best regards.
GMA
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2025-04-18 7:15 AM
Hello @Creative_Stone,
File is located in home directory: ~/.st_workbench
Best regards.
GMA
