FAQs
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 

STlink resets board seconds before programming

DJC
Senior

‎2021-02-15 08:28 AM

I have a rather large build and I notice that my board boots twice when I program it. It seems like ST-link is performing a reset, then does "something" before actually doing the programming of my board. Is there any way to ensure that reset only happens once?

Labels:
0 Kudos
3 REPLIES 3
Uwe Bonnes
Principal III

‎2021-02-16 12:36 PM

Did you perhaps set the hardware watchdog?

0 Kudos
DJC
Senior

‎2021-02-17 09:58 AM

I don't think so... for now my dirty solution is to just put an ifdef DEBUG osDelay(1000) at the start of my code. This is only a mild annoyance during development anyway.

0 Kudos
Uwe Bonnes
Principal III

‎2021-02-17 01:14 PM

Recheck your option bytes!

0 Kudos
Top