Error in Initializing STLINK Nucleo Board H723ZG

Encilatra · ‎2025-02-05

Hi ,

I am using NUCLEO-H723ZG board for my project work. It was working fine and from few days I am facing an issue, when I try to debug or try to run the code an error pops up telling : Error in initializing STLink device. Target no device found.

aditya_prajapati · ‎2025-02-05

Did you try by holding BOOT0 high during reset/power off-on?

Please follow this post
https://community.st.com/t5/stm32-mcus/how-to-unbrick-an-stm32h7-after-setting-the-wrong-power-mode/ta-p/49691

Generally It recover by this.

Imen.D · ‎2025-02-05

Hello @Encilatra and welcome to the Community,

Please have a look at these articles that may help you on your issue:

When your question is answered, please close this topic by clicking "Accept as Solution".
Thanks
Imen

SofLit · ‎2025-02-06

Hello,

Check if you have this issue described in this thread.

To give better visibility on the answered topics, please click on "Accept as Solution" on the reply which solved your issue or answered your question.
PS:
1 - This is NOT an online support (https://ols.st.com) but a collaborative space.
2 - Please be polite in your reply. Otherwise, it will be reported as inappropriate and you will be permanently blacklisted from my help.