Does it support ST-LINK V1?
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2019-05-31 03:26 AM
I'm trying to debug my stm32vldiscovery. The error "ST-LINK V1 not supported" appears. Does it mean that stm32CubeIDE doesn't support it? I haven't seen that in release limitations.
- Labels:
-
ST-Link
-
STM32CubeIDE
-
STM32F1 Series
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2019-07-04 04:15 AM
I am also facing the same issue. Hope the CubeIDE doesnt support ST-Link V1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2019-07-04 04:33 AM
Your wish is likely true. It is a deprecated version.​
Up vote any posts that you find helpful, it shows what's working..
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2020-09-05 02:36 AM
You can still perform "flash and run without debug" with st-link v1 in CubeIDE using ST-LINK_CLI.exe utility, check this thread: