STWBC86 GPIO for LEDs
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2024-05-22 06:49 AM
Hi,
When STWBC86 is operating fully independently without being interfaced with a host system, how can the GPIO be used to drive indicator LEDs to indicate charging status, fault etc? The datasheet shows how these can be programmed to inputs or outputs but how are the relevant functions assigned?
Cheers
Solved! Go to Solution.
- Labels:
-
STWBC86
Accepted Solutions
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2024-05-22 07:54 AM
Hi Jones
Yes, it can use, but different user will need different led, and special FW.
attach 1254 version is EVK board control LED example,
When TX is in charge mode LED will blink,
when rx remove, LED is on.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Email to a Friend
- Report Inappropriate Content
‎2024-05-22 07:54 AM
Hi Jones
Yes, it can use, but different user will need different led, and special FW.
attach 1254 version is EVK board control LED example,
When TX is in charge mode LED will blink,
when rx remove, LED is on.