Problem with inDART and target clock

peterharris9 · ‎2003-08-25

Posted on August 26, 2003 at 05:48

ldefend1 · ‎2003-08-25

Posted on August 25, 2003 at 11:26

Dear Sixtus,

I share your opinion. It seems that your MCU is programmed using an ''unknown'' value. You should replace it and pay attention when you will program the option bytes.

[ This message was edited by: friul on 25-08-2003 15:04 ]

sisto · ‎2003-08-25

Posted on August 26, 2003 at 05:48

Hi friul,

With kind and complete support from Softec Microsystems, that I thank publicly, I opted for the microcontroller change solution. Tomorrow I will receive the chip already programmed for external clock option. I hope to sove my problem and then declare the end of story.

Thanks to all for attention.

Sixtus