About coolingmaster

coolingmaster · 2024-08-27

When I connect to my computer with a USB connection to upload the code to the nucleo-f446re board, that part of the board gets very hot. I didn't forget to jump to the U5V all the time when I connected to the computer with the USB. Why does this happ...

coolingmaster · 2024-08-16

I'm using nucleof446reboard and I'm running out of digital pins. Is there a way to use analog pin as a digital pin??

coolingmaster · 2024-08-09

I'm using the nucleo-f446re board. I'm using the mcp2515, BTS7960, and nrf24l01 modules in this board, but I've been using the digital pins repeatedly due to my mistake. These boards and modules are intended to be used for data collection on the vehi...

coolingmaster · 2024-08-28

I connected it with the data cable that I always used. This doesn't happen when I buy the board for the first time and connect it the same way. But now, when I connect it to my computer using a cable, that part gets very hot within seconds. Where is ...

coolingmaster · 2024-08-16

I have never changed the pins first set on the board separately. The analog pins I mentioned are the pins on the left side of the board. Can I change these pins from cube mx to digital pins?

coolingmaster · 2024-08-09

JP5 was set to U5V, JP6 was removed, and then the voltage was measured.The voltage was measured to be 0.96V.Is my board dead?Should I buy a new one?

coolingmaster · 2024-08-09

I've never modified it on the board. I've only uploaded and used the code using Arduino IDE. I've tried installing and using the Cubemx program, but it's too difficult to use.What should I look at the circuit diagram? My major is mechanical engineeri...

coolingmaster · 2024-08-09

Among CN6 pinsIf you take a picture of 3V3 and GND in a multimeter, it's 0.1VWhen I took 5V and GND, 5V came out.Is there a solution if the onboard debugger is damaged?Is it a hardware issue or a software issue?

User statistics

User Activity

I use the nucleo-f446re board and this part gets very hot.

I want to know how to use analog pins as digital pins. (nucleo-f446re)

Write code in Arduino IDE; not uploading to nucleo-f446re

Re: I use the nucleo-f446re board and this part gets very hot.

Re: I want to know how to use analog pins as digital pins. (nucleo-f446re)

Re: I'm trying to write the code on Arduino IDE and upload it to the nucleo-f446re board, but it's not uploading.

Re: Write code in Arduino IDE; not uploading to nucleo-f446re

Re: I'm trying to write the code on Arduino IDE and upload it to the nucleo-f446re board, but it's not uploading.