About Batuhan35

Batuhan35 · 2024-08-20

Hi,I've developed a custom board and I want to leave an encrypted signature using the STSAFE-A110 chip. However, I'm coding my board in Python, and I'm having trouble figuring out how to interact with the chip. I found the "STSAFE-A complete set of A...

Batuhan35 · 2024-08-08

Hi,I recently ran new code on the STEVAL-PROTEUS1 sensor kit. Before uploading the code, I was able to connect to the STBLE sensor app, but now I can't. I tried a full chip erase using the STM32 CUBE Programmer, and then I re-uploaded the software fi...

Batuhan35 · 2024-08-06

Hi everyone,I am using version 4.5.0 of Nano Edge AI with the STEVAL-PROTEUS1 sensor kit. I am trying to implement anomaly detection for motor vibration. However, when I attempt to add a signal using USB (serial), I occasionally receive meaningless 1...

Batuhan35 · 2024-08-06

Hi,I want to download an old version 3.0.1 of Nano Edge AI studio but I could not find it from the website. It directly download the new version 4.5.0. How can I reach the version 3.0.1?

Batuhan35 · 2024-08-02

Hi,I have emax cf2820 1200kv brushless dc motor and i want to drive it with X-NUCLEO-IHM07M1 motor driver and NUCLEO-G071RB control board. Since the motor I have is not registered in the workbench, I need to import it as a JSON file. Could you tell m...

Batuhan35 · 2024-08-13

Hi @Gael A I got the STM32 F411RE to profile the motor, but now I have a new problem. After watching a few videos on how to profile a motor, I learned that I should generate a project in the Motor Control Workbench first. However, the Motor Control W...

Batuhan35 · 2024-08-12

Hi @Julian E. I am using the STEVAL-PROTEUS1 evaluation kit for anomaly detection. When I try to add a signal via USB, I am unable to receive any values from the accelerometer, even though I can see the data on the STBLE Sensor app. I've tried severa...

Batuhan35 · 2024-08-08

Hello,So you're suggesting that I can work with the STM32G0 after profiling the motor with another MCU?

Batuhan35 · 2024-07-25

Thank you for your response. While reviewing the datasheet, I realized that the J10 jumper needed to be opened to provide power. After doing this, it was fixed. I guess I should read the datasheet more carefully :)

User statistics

User Activity

Seeking Guidance on Integrating STSAFE-A110 Chip with Python

Issue with Reflashing Flash Memory on STEVAL-PROTEUS1 Kit

Can not add signal from usb (serial)

Old version of Nano Edge AI

Import a motor into Motor Control Workbench

Re: Import a motor into Motor Control Workbench

Re: Old version of Nano Edge AI

Re: Import a motor into Motor Control Workbench

Re: STEVAL-PROTEUS1 evaluation kit can not connect via bluetooth