This is another issue found in my endeavors to learn Zephyr. When building I get the following error:warning: orphan section `.stm32_sdram2' from `zephyr/drivers/display/libdrivers__display.a(display_stm32_ltdc.c.obj)' being placed in section `.stm32...
It's the first time I encounter this issue so I'm not familiar with it. It happens with the command "west flash". The problem started after upgrading Zephyr to v3.6.0. Prior to that it was working. Any hints are appreciated!usage: stm32cubeprogrammer...
While looking at the stm32h745xihx-pinctrl.dtsi file I see the slew rate is defined for the QUADSPI pins, but the LTDC pins. Is it set to Very High speed implicitly? I would be concerned if they are set to Low Speed by default. Thanks in advance for ...
Hello,For some reason, I'm not able to enable LWIP on CubeMX 6.11.1, it looks grayed out. I have enabled ETH in RMII mode and CPU DCache.However, if I enable both Cortex M7 and M4, then I'm able to enable LWIP. Is this the expected behavior?
The issue has been resolved. As @Sarra.S pointed out, I needed to update the following line and replace --reset with --reset-mode. board_runner_args(stm32cubeprogrammer "--port=swd" "--reset-mode=hw")Thank you!