About cedric H

cedric H · 2022-01-21

Dear STM32 Motor Control community membersWe are very pleased to announce the new release 5.Y.4 of the XCUBE_MCSDK. This release fix the compatibility issue you may have faced with cubeMX 6.4.This release is the last planed of the 5 versions, and as ...

cedric H · 2024-11-13

Hello @DMeie.2 , V_Q is an output of the PID of the current loop. (same for V_D). The Input of this PID is the error between the target Iq Ref and measured Iq. Is your Iq far from the Iq ref ? If you are in speed mode, the IQ ref is computed by the s...

cedric H · 2024-10-30

Hi, In addition to point 3, if you start your project directly from an IOC generated by the MC Workbench, then your modifications will be kept, but you will not be able to modify your hardware configuration. The only modifications allowed have no con...

cedric H · 2024-10-21

Hello Lukas, Nothing needs to be changed. The resistor network setting the gain of the 3 OPAMPs must remain the same. The difference is internally, instead of connecting PB0 to OPAMP3 as in the schematic we connect it to OPAMP2. 2 Here is the complet...

cedric H · 2024-10-16

Hi all, Our current sensing implementation with 2 ADCs for the STO-PLL or STO-CORDIC requires that at least one phase is connected simultaneously to 2 ADCs. It allows to be able to sample 2 phases in the same clock cycle. This is what we call the sha...

cedric H · 2024-10-02

Hello Florian, Could you attach your stwb6 project file. (renamed in .txt) ? Regards Cedric

User statistics

User Activity

NEW STM32 MC-SDK version 5.Y.4

Re: How to increase Phase Voltage?

Re: Method for starting up at negative RPM

Re: STM Motor Control 6.3 - current sensing issue

Re: STM Motor Control 6.3 - current sensing issue

Re: Sensorless motor Control with mc workbench: Why does motor go to full speed right after start up and to desired speed some seconds later?