About meghasb

meghasb · 2024-04-16

Hi, im trying to work on external Flash with filex and levelx, and the external flash chip is "IS25LP064D ". i was trying to configure the OSPI, in the memory type other than micron, macronix, AP memory and Macronix RAM. I'm not able to see any other...

meghasb · 2024-04-16

Hi all, I'm working on the NOR Flash via OSPI(using as QSPI) with the STM32U585 board. implementing this via filex and levelx, i have done all the configuration referring to the example provided by ST with the minor changes. I'm getting error in the ...

meghasb · 2024-01-21

Hi all,One small doubt on the tamper configuration, is it possible to configure both active and Passive tamper in the Same project/API, or both should be in different project/API. why this doubt is as Seed is not required for Passive tamper, so does...

meghasb · 2024-01-04

Hi all,i want to implement the sleep mode using USB as the source to put the device in to sleep mode and waking the device from the sleep mode. The controller im using is STM32U585. My quarry is, is it possible to do it.? i have implemented the same ...

meghasb · 2023-11-16

Hi all,I'm trying to implement Active Tamper in STM32U585 controller, im trying to generate the SEED, the Seed is getting generated, but the SEED is not getting updated in the SEED reg of tamper, i'm attaching the code and seed values generated for r...

meghasb · 2024-04-17

@NEL M.1 , thanks for the clarification, is their any reference for the driver library for this particular chip. "IS25lp064d-jkle".

meghasb · 2024-03-03

Hi @Bubbles Thanks for the reply, i'm using STMU585 controller.

meghasb · 2024-02-01

Hi Bubbles,Thanks for the reply, i have assigned the static tamper to pin PC13 and Dynamic to PE5-PE6, PA0-PA1. when I'm trying to run the code indusial for static, it detecting, and when I'm running with both(static and dynamic) in one project, stat...

meghasb · 2024-01-22

@Bubbles Thanks.

meghasb · 2023-11-16

Hello @Ced Thanks for the reply, yes SEED is only write, but the (TAMP_ATOR) is read, once the SEED is generated this should be high, its as per my understanding, correct me if im wrong here.

User statistics

User Activity

Is IS25LP064D supported to work on STM32U5 series.

NOR Flash(external memory )- Status error

configuration of the Tamper pins

to make controller entering into the sleep mode and coming out of sleep mode using USB

Tamper: not able to update into the seed registers

Re: Is IS25LP064D supported to work on STM32U5 series.

Re: configuration of the Tamper pins

Re: configuration of the Tamper pins

Re: configuration of the Tamper pins

Re: Tamper: not able to update into the seed registers